Update AWC608 (last update)

[Tech_Marco]

For AWC608:

608150906V7.UG5

(150.52 KiB) Downloaded 371 times

Note: before running the OS patch, make sure that you have erased all files stored in the DSP card or the DSP will not perform properly.


After OS is applied, proceed the following:
For X7, press "Stop" & "Shift" key on the LCD unit to enter the parameter menu where you need to set the mini power % for the RF tube to the lowest. Make sure 'RF tube' is selected. Default is CO2 glass tube.

For both X7 & AWC608, select "No-preignition" on LaserCad parameter setup.

After save the change, make sure to press "RESET" to initiate the DSP for the new setting.


Regards,
Marco