Page 1 of 1

Use clarification for JLD634 ramp/soak controller

Posted: Fri Dec 02, 2011 9:43 am
by ags
Can I use the JLD634 Ramp/Soak controller to run a small kiln requiring 12 amps, 1500 watts? If not, do you carry a controller that will control this type of kiln?

Re: Use clarification for JLD634 ramp/soak controller

Posted: Fri Dec 02, 2011 9:55 am
by Tech_Marco
Need to sue an external SSR. 25A is ok but must attached to a heat sink

Marco