SSD voltage and limit switch
Posted: Thu Sep 04, 2014 11:43 am
First, there are two voltages in the documentation:
Page 1
SSR activated voltage: open circuit: 6V; short circuit: 40mA.
Page 3
2: Relay J1 and J2 as alarm outputs; SSR PID output 8V SSR signal. Target: SV
Is this a type-o or am I missing something.
Second, if I need to use a reed/limit switch, I do not see a feedback circuit. I suppose I should wire it in parallel with the SSR or relay?
Page 1
SSR activated voltage: open circuit: 6V; short circuit: 40mA.
Page 3
2: Relay J1 and J2 as alarm outputs; SSR PID output 8V SSR signal. Target: SV
Is this a type-o or am I missing something.
Second, if I need to use a reed/limit switch, I do not see a feedback circuit. I suppose I should wire it in parallel with the SSR or relay?