JLD-7100 with K type thermo couple?

[jkarpy]

Hi Marco,
I am using the ETC-CB-K1M K type thermo couple. As I understand it , I need to add a resistor between pin 7 and 8. What value resistor is required?

[Tech_Marco]

It's not a resistor. It's for PT100, 3 wires type probe (red label). I believe that my manual has mentioned about it
If you're K type probe, use #9 & #10 without #9.

Marco

[jkarpy]

It's not a resistor. It's for PT100, 3 wires type probe (red label). I believe that my manual has mentioned about it
If you're K type probe, use #9 & #10 without #9.

Marco

I did not get a manual. Where can I download it?

Thanks