JLD634 120v rellay output?

Post Reply
autocharge
Posts: 3
Joined: Sun Jul 15, 2012 4:33 pm
Contact:

JLD634 120v rellay output?

Post by autocharge »

Specification

Dual output SSR(6V, 40mA),
Relay(3A 120V AC)
I'm confused on how to wire and enable the rellay (3a 120v AC) option.

The manual didn't help me any, 3~100 second number value???

should it be done with J1 or J2 output's ??

any help would be nice.

Thank you
richiem
Posts: 270
Joined: Mon Jan 03, 2011 3:47 pm
Contact:

Re: JLD634 120v rellay output?

Post by richiem »

I looked at the manual, and with just a brief perusal, I couldn't figure it out either. I just don't know what the time interval does. It's obvious that the unit can be programmed to use the relays, but anything after that is a mystery. Sorry.
autocharge
Posts: 3
Joined: Sun Jul 15, 2012 4:33 pm
Contact:

Re: JLD634 120v rellay output?

Post by autocharge »

richiem wrote:I looked at the manual, and with just a brief perusal, I couldn't figure it out either. I just don't know what the time interval does. It's obvious that the unit can be programmed to use the relays, but anything after that is a mystery. Sorry.


What I did was to use the SSR to switch on/off a double pole mercury relay for my 220V kiln. Work just as well. Thanks for the reply.
Post Reply

Return to “Temperature Controller”

Who is online

Users browsing this forum: No registered users and 12 guests