hello! i have 1200x900 stage, recently i move the machine and get a new laser tube, now i am trying to align it (i did it a lot of times whithout problems) and i can not get a propper alignment in all the work space, i get the first mirror align ok, then y go to the farest position and align the second mirror ok, but when i go back to the nearest position in y and the farest in x the beam doest match, i checked the alignment between the tube and the machine and its all ok, i have been two days trying and i can not resolve it, the belts are ok, the distance between the tube and the bridge its ok in the nearest and farest position, i made an image to make more clear the positions, 1,2,3 are ok, when i go to 4 it should be ok but its not aligned, if anyone can help me thanks a lot
sory for the dirt i was hopping finishing the alignment to clean
Beam alignment problem
-
- Posts: 13
- Joined: Thu Jun 04, 2015 10:56 am
- Contact:
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Beam alignment problem
It seems to me that the gantry is not well built or aligned. The angle at #3 and #4 may not be in 90 degrees!
Also, your machine looks so dirty without lubrication. It is very bad to the machine
Marco
Also, your machine looks so dirty without lubrication. It is very bad to the machine
Marco
Who is online
Users browsing this forum: No registered users and 3 guests